in

The Yamaha Road Star Warrior Forum

The #1 site for the Yamaha Road Star Warrior

Browse by Tags

  • Engine cutting out on freeway

    [quote user="knyland"] I just went through this there is a module that controles the fuel pump under the seat there is a brown wire that runs from it to the fuse box. The brown wire had coroded almost in half. I pulled the pin cleaned up the wire and resoldered it to the pin and put the harness...
    Posted to Technical Discussion (Forum) by AlanH on 10-29-2008
    Filed under: LAS, Engine Cutting Out
  • Re: Update on cut out problem @ 3000RPM

    [quote user="ohiostar11"] Yr Right Alan! Thanks for the catch. This is the primary reason for ordering a new switch. I almost began to think it was the engine temp sensor because coming to work this morning it was only 73° and holding it at 3000 rpm, it took just a little longer to start to...
    Posted to Technical Discussion (Forum) by AlanH on 06-11-2008
    Filed under: LAS, Engine Cutting Out
  • Re: Update on cut out problem @ 3000RPM

    [quote user="ohiostar11"] I replaced a perfectly good Pick up Sensor assembly, courteous of Yamaha. I sould have the Cut off Switch replaced by Friday, I hope. I will post the minute I get back from the test ride.[/quote]Don't feel bad about the CPS, John aka Terminaatr installed several...
    Posted to Technical Discussion (Forum) by AlanH on 06-09-2008
    Filed under: LAS, Engine Cutting Out
  • Re: Update on cut out problem @ 3000RPM

    If i'm not mistaken, the problem has finally been repaired within the last couple of months. The author of this topic, John aka Terminaatr, had the bike serviced by Mission Yamaha. Not sure if John had the YES warranty but bottom line they had his bike for a month and were able to simulate the high...
    Posted to Technical Discussion (Forum) by AlanH on 06-02-2008
    Filed under: LAS, Engine Cutting Out
  • Re: Engine cutting out on freeway

    [quote user="elijiaht"] I just got off the phone with the dealership, all the recalls have been done. Any other ideas? [/quote]Yes, i would verify that the CPS was replaced by inspecting the rubber grommet for the WHITE ID MARK that exists at the rear side of the clutch case as shown here:...
    Posted to Technical Discussion (Forum) by AlanH on 10-20-2008
    Filed under: LAS, Engine Cutting Out
  • Re: Update on cut out problem @ 3000RPM

    [quote user="Arizona Warrior"] Maybe someone can check the circuits with those sensors the ECU only reads in 4th and 5th speeds?[/quote]The only Input Device (sensor) that is gear related from the transmission is the Neutral Switch .... if not in Neutral the ECU assumes the bike is in gear...
    Posted to Technical Discussion (Forum) by AlanH on 06-10-2008
    Filed under: Electrical, LAS, Engine Cutting Out
Page 1 of 1 (6 items)
Home | Forums | Photos | News | Classifieds | Warrior of the Month | Contact Us | About Us | Donate | Advertise | Legal & Privacy | Rules
©2002-2009 RSWarrior.com. All rights reserved.
Site created and maintained by Sean Kearney