Got mine today, so of course I had to test fit it...it doesn't exactly install its self. First round tried w/no shims, the bottom left corner rested against the tire (stock size but upgraded to avon storm) So I shimmed out the left rear mount with 2 quarter in washers, this straightened the back side out but then the right front was resting against the tire, unfortunatly I could only get one washer in to shim it out because that bolt is the collared one that the fork guard slides into with the rubber gromit, and it was a little short when I had 2 washers behind it. Just the one gave me clearance but I can't get it centered, the right side gap is pretty tight up front. After an hour and a half I had it on and not rubbing...let me tell ya it is both LOW AND MEAN...damn good lookin unit. I've got a friend who builds bikes and does custom paint (he is currently redoing his custom for the third or fouth time) so I'm gonna consult him (hope its a free consultation 
) about making it fit better. I also got a chin scoop which I didn't try to mount but it butts up nicely and I don't expect too much trouble from it. Once I get it the way I want it the paint will start flyin' , but first I gotta do the 8k mile maintenance, good thing riding season ended yesterday.
Like to hear if anyone else got one,how it fits and what you did to make it do so. I doubt I'll post any pics until the custom paint is done. Seeing that new fender and spoiler has given me tunnel vision to the bike now and all I can think about is painting it, so pics aren't that far off, getting my hands on a camera will probbably be harder than getting it in paint.