*2
Warning control when unable to start engine
This control is effected when any one of the
conditions listed below is present and the
starter switch is turned ON:
a. Battery voltage below the specified value
(defective Fuel injection system relay,
engine stop switch turned OFF, or drained
battery)
b. One of the fault codes listed below has
been detected (self-diagnostic code 12, 19,
30, 41, or 50 is output):
(12: faulty crankshaft position sensor signal)
(19: open circuit in sidestand input line)
(30: a fall has been detected)
(41: open or short circuit in lean angle cutoff
switch)
(50: ECU memory check error)
cltgt:Funny thing happened when doing a Bikers For Tots Poker Run.. Bike had been running fine until the 3rd stop. When I went to start the bike, it would not turn over and the engine light was flashing rapidly. Bike was in neutral. I turned the key off let it sit for about 30 seconds, turn the key to on position and the bike started right up. It happened again at the 4th stop, so I got it started and took it straight home. I let it sit all week. I went to start it yesterday and it started right up with no issue. Has anyone ever had this happen before? Could it be the battery? Battery did test fine...